Differences between revisions 9 and 10
Revision 9 as of 2007-10-10 17:46:26
Size: 1707
Editor: pgas
Comment: remove the discussion
Revision 10 as of 2008-11-22 14:09:52
Size: 1707
Editor: localhost
Comment: converted to 1.6 markup
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
[[Anchor(faq82)]] <<Anchor(faq82)>>

Why is $(...) preferred over `...` (backticks)?

For several reasons:

  • It's easier to read. The character ` is difficult to read with small or unusual fonts.

  • It's easier to type. The physical key to produce the character may be located in an obscure place on non-US keyboards.
  • The backtick is easily confused with a single quote. People who see $() don't normally press the wrong keys. On the other hand, some people who see `cmd` may mangle it into 'cmd' because they don't know what a backtick is.

  • It makes nesting command substitutions easier. Compare:
    •   x=$(grep $(dirname "$path") file)
        x=`grep \`dirname "$path"\` file`
    It just gets uglier and uglier after two levels.
  • Backslashes (\) inside backticks are handled in a non-obvious manner:
    •   $ echo "`echo \\a`" "$(echo \\a)"
        a \a
        $ echo "`echo \\\\a`" "$(echo \\\\a)"
        \a \\a
  • Nested quoting inside $() is far more convenient.

    •   echo "x is $(echo "$y" | sed ...)"

    In this example, the quotes around $y are treated as a pair, because they are inside $(). This is confusing at first glance, because most C programmers would expect the quote before x and the quote before $y to be treated as a pair; but that isn't correct in shells. On the other hand,

    •   echo "x is `echo \"$y\" | sed ...`"
    requires backslashes around the internal quotes in order to be portable. Bourne and Korn shells require these backslashes, while Bash and dash don't.

The only time backticks are preferred is when writing code for the oldest Bourne shells, which do not know about $().

BashFAQ/082 (last edited 2021-07-18 10:40:15 by geirha)