How can I redirect the output of 'time' to a variable or file?

Bash's time keyword uses special trickery, so that you can do things like

time find ... | xargs ...

and get the execution time of the entire pipeline, rather than just the simple command at the start of the pipe. (This is different from the behavior of the external command time(1), for obvious reasons.)

Because of this, people who want to redirect time's output often encounter difficulty figuring out where all the file descriptors are going. It's not as hard as most people think, though -- the trick is to call time in a SubShell or block, and then capture stderr of the subshell or block (which will contain time's results). If you need to redirect the actual command's stdout or stderr, you do that inside the subshell/block. For example:

A similar construct can be used to capture "core dump" messages, which are actually printed by the shell that launched a program, not by the program that just dumped core:

./coredump >log 2>&1           # Fails to capture the message
{ ./coredump; } >log 2>&1      # Captures the message

The same applies to job control messages:

$ { sleep 1 & } >log 2>&1
$ cat log
[1] 10316
[1]+  Done                    sleep 1

Of course you may opt to redirect to /dev/null instead of a file.


BashFAQ/032 (last edited 2017-02-23 21:36:09 by GreyCat)