Differences between revisions 6 and 7
Revision 6 as of 2009-12-30 18:38:21
Size: 1657
Editor: MatthiasPopp
Comment:
Revision 7 as of 2010-01-22 19:08:27
Size: 1968
Editor: GreyCat
Comment: core dump messages work similarly
Deletions are marked like this. Additions are marked like this.
Line 37: Line 37:
A similar construct can be used to capture "core dump" messages, which are actually printed by the shell that launched a program, not by the program that just dumped core:

{{{
   ./coredump >log 2>&1 # Fails to capture the message
   { ./coredump; } >log 2>&1 # Captures the message
}}}

How can I redirect the output of 'time' to a variable or file?

Bash's time keyword uses special trickery, so that you can do things like

   time find ... | xargs ...

and get the execution time of the entire pipeline, rather than just the simple command at the start of the pipe. (This is different from the behavior of the external command time(1), for obvious reasons.)

Because of this, people who want to redirect time's output often encounter difficulty figuring out where all the file descriptors are going. It's not as hard as most people think, though -- the trick is to call time in a SubShell or block, and then capture stderr of the subshell or block (which will contain time's results). If you need to redirect the actual command's stdout or stderr, you do that inside the subshell/block. For example:

  • File redirection:
       bash -c "time ls" 2>time.output      # Explicit, but inefficient.
       ( time ls ) 2>time.output            # Slightly more efficient.
       { time ls; } 2>time.output           # Most efficient.
    
       # The general case:
       { time some command >stdout 2>stderr; } 2>time.output
  • CommandSubstitution:

       foo=$( bash -c "time ls" 2>&1 )       # Captures *everything*.
       foo=$( { time ls; } 2>&1 )            # More efficient version.
    
       # Keep stdout unmolested.
       exec 3>&1
       foo=$( { time bar 1>&3; } 2>&1 )      # Captures stderr and time.
       exec 3>&-
    
       # Keep both stdout and stderr unmolested.
       exec 3>&1 4>&2
       foo=$( { time bar 1>&3 2>&4; } 2>&1 )  # Captures time only.
       exec 3>&- 4>&-

A similar construct can be used to capture "core dump" messages, which are actually printed by the shell that launched a program, not by the program that just dumped core:

   ./coredump >log 2>&1           # Fails to capture the message
   { ./coredump; } >log 2>&1      # Captures the message


CategoryShell

BashFAQ/032 (last edited 2018-07-26 21:28:38 by GreyCat)